1 1

22" DTF Gang Sheet - UPLOAD (Advanced Users)

22" DTF Gang Sheet - UPLOAD (Advanced Users)

$6.00 USD
$6.00 USD
Sale Sold out
Size
View full details

Fresh Prints press guide

What is Hot Peel DTF?

A ready-to-press, full-color transfer made for fast production. Your artwork is printed onto film with a white underbase and adhesive already applied—so there is no vinyl cutting, weeding, or color-by-color layering.

Full colorNo weedingMost fabricsPeel while hot
Fresh Prints Hot Peel DTF transfer, heat press, and finished shirt
Pro quality
skip the wait
01

Millions of colors

Fine detail, gradients, and a bright white underbase in one finished transfer.

02

No weeding

Trim apart the transfers you need, then place, press, and peel—no vinyl weeding required.

03

Built for mixed orders

A strong starting choice for cotton, 50/50 blends, polyester, and many common garments.

04

Peel immediately

Remove the carrier while it is hot for a faster production rhythm.

Start here

Fresh Prints Press Tips

These are starting settings for our Hot Peel transfers. Heat presses and garments vary, so test unfamiliar fabric and follow the garment care label.

Cotton + 50/50320–325°FStart at the lower end when testing a new garment.
Poly + synthetics280–300°FStart low to reduce scorch marks and dye migration.
Press time10–15 SECUse one complete press without lifting early.
PressureMED–FIRMEven pressure matters more than forcing maximum pressure.
Peel methodHOT PEELPeel immediately in one smooth, continuous motion.

Finish strong: after peeling, cover the design with parchment or the approved cover sheet and post-press for 5 seconds.

Four-step application

Press it right the first time.

The repeatable workflow for clean edges, strong adhesion, and faster production.

Black and white shirts positioned on a dual-platen heat press01

Prep the garment

Move seams, collars, pockets, buttons, and zippers off the platen. Pre-press for 3–5 seconds to flatten the fabric and remove moisture.

Fresh Prints Hot Peel DTF transfer positioned on a black shirt before pressing02

Position the transfer

Place the printed adhesive side against the fabric. The artwork should read correctly through the clear carrier. Keep every part of the design on a flat pressing surface.

Heat press engaged on a Fresh Prints Hot Peel DTF transfer03

Press evenly

Apply the correct temperature, 10–15 seconds, and medium-to-firm pressure. Do not open the press early, slide the garment, or let a seam steal pressure from the design.

Fresh Prints Hot Peel DTF carrier film peeled from a finished black shirt04

Peel hot + finish

Lift one corner and remove the carrier immediately in one confident motion. If any area lifts, stop, lay the carrier back down, and repress before continuing.

Do this

Build a repeatable press routine.

  • Test unfamiliar garments and presses.
  • Verify the platen is actually at temperature.
  • Keep the print area flat and obstruction-free.
  • Peel immediately in one smooth motion.
  • Complete the covered 5-second post-press.

Avoid this

Do not guess through a failure.

  • Do not mix instructions from another transfer brand.
  • Do not press over collars, seams, or zippers.
  • Do not rip the film away if the image begins lifting.
  • Do not press a damp or wrinkled garment—pre-press it first.
  • Do not wash, stretch, or heavily handle the garment for 24 hours.

After pressing

Make the print last.

  1. 24 HRWait before the first wash.
  2. INSIDE OUTWash cold on a gentle cycle.
  3. LOW HEATAir dry when possible or tumble dry low.
  4. NO DIRECT IRONKeep high heat off the transfer face.